The Irristart is built in-house by our own qualified electricians; fully tested and ready to install pump start relay unit. Requiring a 24v input signal from an irrigation controller (or other source) to run the pump. The panel consists of a waterproof enclosure to IP56 incorporating a motor contactor, overload, 24v relay switch and base and a connector strip.

The panels are incredibly easy to install and just requires a 230v single phase electrical supply, connection of the 24v pump and input signal from a controller source. Please note the Irristart is supplied with full wiring instruction. Cable glands are not provided. Max motor size 0.75kW/6 amps or 1.5 kW/9 amps depeding on panel required

Please note there is no facility to add a float switch as in earlier versions. Another control panel, such as the Pump Start Pro 230v, should be chosen if this option is required.